Garage door won't close: sensor repair in Eastchester

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (914) 281-2395

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Eastchester realigns or replaces the sensors and tests the safety reverse.

Chain-drive garage door opener under exposed rafters

Doors that won't close in Eastchester

Eastchester packs a lot of houses into five square miles. In Crestwood and Tuckahoe, older homes on small lots have narrow garages, some shared or reached by a common driveway, with sensors within inches of the car. In Chester Heights and Huntley Estates, 1920s and 30s Tudors and Colonials have garages built for smaller cars. Around Lake Isle, Twin Lakes and Hickory Hills, hillier lots send runoff and leaves to the door. On California Ridge, garages under the house stay damp. With cars squeezed in this tightly, a bumped bracket is the most common reason a door in Eastchester stops closing.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Eastchester

  • Twin Lakes and Hickory Hills: Hilly mid-century neighborhoods with tuck-under and attached garages.
  • Huntley Estates and California Ridge: Splits and colonials on sloped lots in the north and west.

See the full Eastchester service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 281-2395
Call (914) 281-2395